collapse

* Benutzer Info

 
 
Willkommen Gast. Bitte einloggen oder registrieren. Haben Sie Ihre Aktivierungs E-Mail übersehen?

* Suchfunktion


* HMA

Autor Thema: Ätzteile 1/350 HMS Hood fertig  (Gelesen 3865 mal)

0 Mitglieder und 1 Gast betrachten dieses Thema.

Offline Foeth

  • Matrose
  • *
  • Beiträge: 4
    • OnTheSlipway
Ätzteile 1/350 HMS Hood fertig
« am: 11 Februar 2010, 10:03:48 »
I have updated My blog. In English, of course. This is part of my project which runs over 10 years now?!

The etch set presented in Custom Photoetch Set Part II is now done. There was a slight delay as set received some minor adjustments as required by the etcher and I felt I could add one more part. The set was etched by Saemann Ätztechnik in Germany, with excellent results. Here's the result:



I had three copies make. I decided to spread around some parts to that I would need at least two sets, and one backup. This was probably a good decision; the parts are already falling out of the set as the material holding them in place was designed a bit too thin. An overview with most of the parts is below. The color is a bit off, the material is silvery in appearance.



All stairs from the previous set were repeated; I made a design error and couldn't fold the steps without breaking them. This should be better, or so I hope. Each deck has stairs etched to size to account for the different deck heights. The spacing between the steps was changed accordingly, so you shouldn't be able to notice the slight variations in height and span. The model will depict HMS Hood just under way, so the accommodation ladders and stairs on the quarterdeck will be stored.

1 Shelter deck of signal platform
2 Signal platform to conning tower platform
3 Conning tower platform to Admiral's bridge (large)
4 Behind torpedo control position
5 Admiral's bridge to fore bridge (direct)
6 Admiral's bridge to fore bridge (via upper plotting position)
7 Forecastle deck to shelterdeck (wide, outboard)
8 Forecastle deck to shelterdeck (narrow, on centerline)
9 Conning tower platform to Admiral's bridge (small)
10 Air defense platform to roof torpedo control position
11 Accommodation ladder, shelterdeck
12 Admiral's accommodation ladder, quarterdeck
13 Fore bridge to compass platform
14 Forecastle deck to shelterdeck (forward)
15 Quarterdeck to shelterdeck
16 Quarterdeck stair platform (stowed version)
17 Foot plates with "Hood", (Checkered foot plates around 12)
18 Flag lockers, grid plus cabinet



A large selection of cordage reels is included. I found 5 different types and designed them based on photographs on board HMS Hood, and various museum ships.

1 New Quarterdeck hatch aft of Y-turret
2 Hatches for cabinet on main starfish
3 Small cordage reels
4 Medium cordage reeks
5 Very large cordage reels
6 Large cordage reels
(Very small cordage reels places elsewhere)
7 Detail for X-turret and 20" signal light detail
8 Night life buoy (repeat)
9 UP ammo locker hatches (repeat)
10 Assorted detail for electrical winches
11 Semaphores
12 Rigging detail (repeat)
13 Funnel walkways
14 Type 279 radar aerial



1 Detail for main derrick
2 Assorted eyelets for all derricks
3 Main derrick pulley frames
4 Crane hook main derrick
5 Crane hook small derrick
6 Assorted detail paravanes
7 Assorted detail Pompom director Mk II
8 Escape manhole hatch (omitted in previous set)
9 Assorted detail 4" gun fuse setters
10 Searchlight lanterns
11 Carley float type 17, 8x12 ft
12 Carley float type 20, 5x10 ft
13 Carley float type 19, 5x8 ft
14 Davit detail



1 Checkered foot plates
2 Small outboard platform of forecastle deck
3 Flag lockers, grid plus cabinet
4 New torpedo hatch (near forward breakwater)
5 Very small cordage reels (not fixed properly)
6 Very small mushroom vents grid
7 Assorted eyelets
8 Awning detail (perhaps too small)
9 Railing around staircases, one end open
10 Railing around staircases, both ends open
11 Torpedo head hatch hinge (on the side of the hull)
12 Hatches ammo storage on shelterdeck
13 Railing around searchlight positions
14 Railing for funnel walkway
15 Railing superstructure (chain)



1 Assorted detail octuple Pompom Mk V
2 Assorted detail octuple Pompom Mk VI



1 Assorted detail searchlight director
2 Assorted detail air-lookout position
3 Assorted detail air-defense officer's sight
4 Assorted detail Pompom director Mk I
5 New hatch capstan engine room (near anchors)
6 Aerials  MF/DF office
7 Hatch
8 Vickers quad machine gun (repeat)
9 35ft fast motor boat  ladders (accidentally added twice)
10 Main mast stays
11 Hatch cover frame
12 Hawse pipe cover
13 Hatches
14 Quad Pompom



I decided not to use any commercial railing, as HMS Hood has at least 5 styles (one being for the funnel walkway). Note that the railing style on the main deck is 3-bar, wide, while it has a shorter spacing between stanchions on the shelterdeck. The rest of the railing on HMS Hood is all 2-bar.

1 Railing quarterdeck and forecastle deck
2 Railing shelterdeck
3 Railing superstructure (chain)
3 Railing superstructure (bar)